Metrologic MS9524 VoyagerPDF Series Installation And User Manual page 26

Single-line hand-held laser scanner
Hide thumbs Also See for MS9524 VoyagerPDF Series:
Table of Contents

Advertisement

P
ROGRAMMING
4.
During programming, the motor and laser turn off. YOU CANNOT SCAN A
BAR CODE WHILE IN SERIAL PROGRAM MODE.
5.
There is a 20 second window between commands. If a 20-second timeout
occurs, the scanner will send a [nak] and you must start over.
6.
To enter serial program mode, send the following command
[stx]999999[etx].
7.
To exit serial program mode, send the following command [stx]999999[etx],
the scanner will respond with an [ack] followed by 3 beeps.
8.
This mode uses the current Baud Rate, Parity, Stop Bits and Data Bits
settings that are configured in the scanner. The default settings of the
scanner are 9600, Space, 2, 7 respectively. If a command is sent to the
scanner to change any of these settings, the change will NOT take effect
until after serial program mode is exited.
EXAMPLE #2:
The following example will set the scanner to the factory default settings,
Disable Scanning of Code 128 bar codes, change the beeper tone, and add
a "G" as a programmable prefix.
FEATURE
Enter Program Mode [stx]999999[etx]
Load Defaults
Disable Code 128
Alternate Tone 1
Prog. Prefix #1
Code Byte 0
Code Byte 7
Code Byte 1
Exit Program Mode [stx]999999[etx]
The scanner will beep three times!
The commands sent to the scanner do not include the small superscripted
'3' that you see in front of each bar code string in the MetroSelect manual.
THE '3' SHOULD NOT BE SENT, IT IS A CODE TYPE DESIGNATION
ONLY!
As you will note for commands requiring additional bar codes to be scanned
(such as prefixes, suffixes, timeouts, etc.), simply send the code bytes in the
same order that you would normally scan the bar codes.
22
M
(
ODES
CONTINUED
HOST
COMMAND
[stx]999998[etx]
[stx]100113[etx]
[stx]318565[etx]
[stx]903500[etx]
[stx]0[etx]
[stx]7[etx]
[stx]1[etx]
)
ASCII REPRESENTATION
02h 39h 39h 39h 39h 39h 39h 03h [ack] or 06h
02h 39h 39h 39h 39h 39h 38h 03h [ack] or 06h
02h 31h 30h 30h 31h 31h 33h 03h [ack] or 06h
02h 33h 31h 38h 35h 36h 35h 03h [ack] or 06h
02h 39h 30h 33h 35h 30h 30h 03h [ack] or 06h
02h 30h 03h
02h 37h 03h
02h 31h 03h
02h 39h 39h 39h 39h 39h 39h 03h [ack] or 06h
SCANNER
RESPONSE
[ack] or 06h
[ack] or 06h
[ack] or 06h

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ms9544 voyagerpdf series

Table of Contents