Metrologic Voyager MS9535 Connecting To A Usb Bt Adapter

Bt scanner

Hide thumbs Also See for Voyager MS9535:

Download this manual

Connecting a Metrologic MS9535 to a USB BT

Adapter

I. Scope

This document will provide a brief description of how to connect the Metrologic

MS9535 scanner to a USB BT adapter.

Note: Adapters differ from manufacturer to manufacturer. This document was based on an

adapter from Widcomm and description may differ based on the manufacturer of the adapter you

are using.

II. Getting Started

Observe USB dongle, install into USB on laptop.

Scan "Provide Service" bar code found in the I&U Guide.

³ 0 0 0 C A 7 0 0 0 0 0 0

Click on

to open the USB dongle software.

Select "Entire Bluetooth Neighbourhood" to begin searching for devices.

Available devices will appear on the screen. Select the VoyagerBT scanner. Use

the last 4 digits from Voyagers Serial Number as the key for the secure

connection.

MS9535 VoyagerBT

Page 1 Connecting a Metrologic MS9535 to a USB BT Adapter I. Scope This document will provide a brief description of how to connect the Metrologic MS9535 scanner to a USB BT adapter. Note: Adapters differ from manufacturer to manufacturer. This document was based on an adapter from Widcomm and description may differ based on the manufacturer of the adapter you are using.
Page 2 You can use it not only for Voyager BT but for all serial scanners. After you have installed Softwedge, start it, and select the virtual BT communication port. Select “Port Selected”. The Port Status will change to “Connected”. Metrologic Software is available at: http://www.europe.metrologic.com/europe/engl/support/software/index.html MS9535 VoyagerBT...