Quick Start; Installing The Scanner To The Host System - Metrologic MS9500 Voyager Series Installation And User Manual

Installing the Scanner to the Host System

1. Turn off the host system.
2. Make the proper PowerLink cable connections to the scanner.
Please refer to the Quick Start section of this manual for proper
installation of the cable and power supply. NOTE: If the Voyager is
receiving power from the host system, please skip step #2 and step
#3 in the Quick Start section of this manual.
3. Connect the PowerLink cable to the proper port on the host system.
4. Turn on the host system.
Note: Plugging the scanner into a port on the host system does not
guarantee that scanned information will be communicated properly to
the host system. The scanner is shipped from the factory programmed
with default settings. Please refer to the MetroSelect Configuration
Guide (MLPN 2407) for instructions on changing the scanner's
configuration. In addition, please check that the scanner and host
system are using the same communication protocol.
2
3
1
4
4