Audible Indicators - Metrologic MS9500 Voyager Series Installation And User Manual

Audible Indicators

When the Voyager is in operation, it provides audible feedback. These
sounds indicate the status of the scanner. Eight settings are available
for the tone of the beep (normal, 6 alternate tones and no tone). To
change the tone, refer to the MetroSelect Programming Guide MLPN
2407.
One Beep
When the scanner first receives power, the green
LED will turn on, then the red LED will flash and the
scanner will beep once. (The red LED will remain on
for the duration of the beep.) The scanner is ready to
scan.
When the scanner successfully reads a bar code, the
red LED will flash and the scanner beeps once (if
programmed to do so). If the scanner does not beep
once and the green light does not flash, then the bar
code has not been successfully read.
Razzberry Tone
This tone is a failure indicator. Refer to
"Failure Modes" page 13.
Three Beeps - During Operation
When entering configuration mode, the red LED will
flash while the scanner simultaneously beeps three
times. The red and green LEDs will continue to flash
while in this mode. Upon exiting configuration mode,
the scanner will beep three times, and the LEDs will
stop flashing.
When configured, 3 beeps can also indicate a
communications timeout during normal scanning
mode.
When using one-code-programming, the scanner will
beep three times (the current selected tone), followed
by a short pause then by a high tone and a low tone.
This tells the user that the single configuration bar
code has successfully configured the scanner.
Three Beeps - On Power Up
10