Door Handle Assembly; Blower (Optional) - Quadra-Fire DISCOVERY-III Installation Manual

C. Door Handle Assembly
1. Install fiber handle to door handle rod.
Door Handle
Fiber Handle
Figure 17.1
Figure 17.2
August 01, 2016
D. Blower (Optional)
Tools Required: #2 Phillips head screwdriver
1. Locate bolts supplied with the blower.
2. Align holes in mounting flange of blower with bolt holes in
appliance. Blower should be positioned at bottom of rear
outer skin as shown in Figure 17.2
3. Re-insert and tighten bolts, securing blower onto outer
wall of appliance.
4. Place the bracket containing the snap disc and magnet
under the bottom left rear corner.
See Owner's Manual for detailed operating instructions
for the blower and snap disc.
CAUTION
Shock Risk.
• Do NOT remove grounding prong from plug.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
• Plug directly into properly grounded 3 prong receptacle.
MANUAL: Overides the
Snap Disc
AUTO: Fan will turn
ON/OFF Automatically
by the Snap Disc
Controls the Fan Speed
7037-158C
Discovery III
17