Step 3: Presetting Radio Stations - Sony MHC-V808 Operating Instructions Manual

Step 3: Presetting
radio stations
You can preset up to 40 stations, 20 for FM, 10
for MW and 10 for SW.
3,5 6 1 4
POWER
1
Press TUNER/BAND repeatedly
until the band you want appears in
the display.
Each time you press this button, the
band changes as follows:
FM n MW n SW
2
Press TUNING MODE repeatedly to
select "AUTO."
8
3
Turn the jog dial.
The frequency indication changes and
scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
stereo programs) appear.
2
4
Press TUNER MEMORY.
A preset number appears in the display.
5
Turn the jog dial to select the preset
number you want.
6
Press ENTER/NEXT.
The station is stored.
7
Repeat steps 1 to 6 to store other
stations.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly to select
"MANUAL" in step 2, then turn the jog dial
to tune in the station.
To change the preset number
Start over from step 1.
To change the AM tuning interval
The AM tuning interval is factory-preset to 9 kHz.
To change the AM tuning interval, tune in any AM
station first, then turn off the power. While holding
down the ENTER/NEXT button, turn the power
back on. When you change the interval, AM preset
stations will be erased. To reset the interval, repeat
the same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or a power failure
occurs.
AUTO
Preset number
AUTO
TUNED
STEREO
VOLUME
MHz
TUNED
STEREO
VOLUME