Advertisement
• InSleep 1 andSleep 2,the airconditioner willrunaccording t oa group ofpresetting
temperature c urves.
• Sleep3
- the sleep curve setting under DIY Sleep mode:
(1) Under Sleep 3 mode, long press "AIR" button, the remote controller will enter
the setting of personalized sleep. In this case, the timer zone of remote controller
will display "1 hr" and the set temperature zone "88" will display the corresponding
temperature of the last set sleep curve and blink (The first entering will display
according to the initial curve setting value of manufacturer);
• (2) Press "+" and "-" button to adjust the corresponding temperature. After adjusting,
press "AIR" button to confirm it;
• (3) At this time, the timer time on the remote controller will increase automatically
by
1hr (that is "2 hr" or "3 hr" ,,, or "8 hr"). The set temperature
zone "88" will display the
corresponding temperature of the last set sleep curve and blink;
• (4)Repeat step(2) and step (3) until 8-hour temperature setting is finished, then the
sleep curve is set successfully. After that, remote controller will resume displaying the
original timer time and temperature zone will resume displaying the original set
temperature.
• Sleep 3 - the sleep curve inquiry under DIY Sleep mode:
User can inquire the set sleep curve according to the setting method of sleep curve.
Enter the setting of personalized sleep but do not change the temperature. Then
press "AIR" button to confirm the setting.
Note: In the above setting or inquiry procedure, if there is no button pressing within
10s, remote controller will automatically exit the sleep curve setting and resume the
HEATING button is pressed during the setting or inquiry procedure, remote controller
original display. If ON/OFF, MODE, TIMER, HUMIDIFY, SLEEP, COOLING or
will also exit the sleep curve setting.
• Sleep 4 is Siesta mode. The set temperature will change automatically according to
the features of siesta.
• Sleep function will be disabled if the air condition is restarted after power failure;
when sleep function is turned on, quite fan speed will be also turned on.
• Sleep function can not be set in AUTO mode.
• Press this button 3s can set wifi function on or OFF.
• At OFF status,press mode button and wifi button,can reset wifi mode parameter.
and open wifi function.
-13-
Advertisement
