Station Preset - Subaru 2008 Outback Owner's Manual

NOTE
While you are holding down either side
of the TUNE/TRACK button, the tuning
frequency will not stop changing even
if the frequency of a receivable station
is reached.
! Stereo indicator
The stereo indicator "ST" will come on
when an FM stereo broadcast is received.
! Seek tuning (SEEK)
If you press the " " or "
SEEK/SCAN button briefly, the radio will
automatically search for a receivable
station and stop at the first one it finds.
This function may not be available, how-
ever, when radio signals are weak. In such
a situation, perform manual tuning to
select the desired station.
! Scan tuning (SCAN)
If you press the "
SEEK/SCAN button for 0.5 second or
longer, the radio will switch to scan mode.
In this mode, the radio scans through the
radio band until a station is found. The
radio will stop at the station for 5 seconds
while displaying the frequency, after which
scanning will continue until the entire band
has been scanned.
Press the "
again to cancel the scan mode and to stop
" side of the
on any displayed frequency.
If you hold down the "
button, the radio will scan up the fre-
quency band (from low frequencies to high
frequencies). If you hold down the "
side of the button, the radio will scan down
the frequency band (from high frequencies
" or " " side of the
" or " " side of the button
" side of the
"
Audio
to low frequencies).
Automatic tuning may not function prop-
erly if the station reception is weakened by
distance from the station or proximity to
tall buildings and hills.
& Station preset
! How to preset stations
1. Press the "FM AM" button to select
FM1, FM2 or AM reception.
2. Press the " " or " " side of the
button or tune the radio manually until the
desired station frequency is displayed.
3. Press one of the preset buttons for
more than 1.5 seconds to store the
frequency. If the button is pressed for less
than 1.5 seconds, the preceding selection
will remain in memory.
NOTE
. If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all stations stored in the
preset buttons are cleared. If this
occurs, it is necessary to reset the
preset buttons.
. If a cell phone is placed near the
radio, it may cause the radio to emit
noise when it receives calls. This noise
– CONTINUED –
5-11