Subaru 2008 Outback Owner's Manual page 287

7-46
Starting and operating
Cruise control
Cruise control enables you to maintain a
constant vehicle speed without holding
your foot on the accelerator pedal and it is
operative when the vehicle speed is 25
mph (40 km/h) or more. Make sure the
main switch is turned "OFF" when the
cruise control is not in use to avoid
unintentionally setting the cruise control.
NOTE
If you press the main switch button
while turning the ignition switch "ON",
the cruise control function is deacti-
vated and the "CRUISE" indicator light
flashes. To reactivate the cruise control
function, turn the ignition switch back
to the "Acc" or "LOCK" position, and
then turn it again to the "ON" position.
WARNING
Do not use the cruise control under
any of the following conditions. This
may cause loss of vehicle control:
. driving up or down a steep grade
. driving on slippery or winding
roads
. driving in heavy traffic
& To set cruise control
1. Push the "CRUISE" main switch but-
ton.
Vehicle with SI-DRIVE
Vehicle without SI-DRIVE
The " " indicator light on the combi-
nation meter will come on.
2. Depress the accelerator pedal until the
vehicle reaches the desired speed.
3. Push the "SET/COAST" button and