Station Preset - Subaru FORESTER Manual

available, pressing the "DISP" button
changes the display among PS and
frequency. The initial setting is "PS".
NOTE
The maximum number of characters
that can be displayed for PS is 8.
& Station preset
! How to preset stations
1. Press the "FM AM" button to select
FM1, FM2, FM3 or AM reception.
2. Press the " " or " " side of the
SEEK button or tune the radio manually
until the desired station frequency is
displayed.
3. Press one of the preset buttons for
more than 1.5 seconds to store the
frequency. If the button is pressed for less
than 1.5 seconds, the preceding selection
will remain in memory.
NOTE
. If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all stations stored in the
preset buttons are cleared. If this
occurs, it is necessary to reset the
preset buttons.
. If a cell phone is placed near the
radio, it may cause the radio to emit
noise when it receives calls. This noise
does not indicate a radio fault.
! Selecting preset stations
Presetting a station with a preset button
allows you to select that station in a single
operation. Up to six AM, FM1, FM2 and
FM3 stations each may be preset.
! Auto-store
Using the Auto-store function, you can
automatically store 6 stations on the
current waveband by simply pressing the
"A/S" button. Use Auto-store to quickly
find the strongest stations, for example
when traveling through different reception
areas.
Audio
NOTE
. When you use Auto-store, the new
stations replace any stations pre-
viously stored.
. Interrupting Auto-store: If you acci-
dentally press the "A/S" (Auto-store)
button, you can cancel the Auto-store
function before the AST function has
been completed as follows.
– switching to the other source
mode
– switching to the other band
– turning the tune dial
– operating the seek key
5-13