Subaru 2008 Outback Owner's Manual page 135

3-16
Instruments and controls
To change the current setting, take the
following steps.
1. Within 12 seconds after turning on the
ignition switch, press the " /SET" switch
for at least 2 seconds.
2. T h e d i s p l a y s h o w s " M E T E R
SETTING", and then changes to the
setting screen.
3. When the setting screen is displayed,
select "Initial movement" by pressing the
" " or " " switch. And press the " /
SET" switch to enter the setting process.
4. Select "ON" for activated initial move-
ment or "OFF" for deactivated initial move-
ment by pressing the " " or "
And press the " /SET" switch to decide
the desired setting.
If you do not need to change the previous
setting, select " " and press the " /SET"
switch.
5. Select "End" by pressing the "
" " switch. And press the " /SET" switch
" switch.
to finish the meter setting menu.
NOTE
. Your vehicle's initial movement
setting of the meter/gauge needles
has been set for activation "ON" at
the time of shipment from the factory.
. If you turn the ignition switch to the
"Acc" position, turn the ignition switch
to the "LOCK" position, or open and
close the driver's door during the
setting procedure, the new setting will
be canceled.
. It is not possible to cancel sequen-
tial illumination of the combination
meter while sequential illumination is
actually taking place. Cancel sequen-
" or