Stacked Iso Din Head Unit Provision - Metra Electronics 95-3304 Installation Instructions Manual

Stacked ISO DIN head unit provision

1. Slide the appropriate bracket into the
trim plate aligning the holes in the trim
plate to the clips on the bracket.
(Figure A)
2 Slide the stacked ISO DIN units into the
trim plate bracket assembly and secure
the unit to the kit using the screws
supplied with the head unit. (Figure B)
3. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
4. Reassemble dash in reverse order
of disassembly.
Kit Assembly 95-3304
8
(Figure A)
(Figure B)