Speaker Disassembly Instructions - Aiwa XR-EC10 Service Manual

SPEAKER DISASSEMBLY INSTRUCTIONS -1/1

QQ
Type.1
3 7 63 1515 0
Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel. Remove the screws of each speaker unit
andthen remove the speaker units.
Type.2
Remove the grill frame and four pieces of rubber caps by pulling out
with a flat-bladed screwdriver. Remove the screws from hold where
installed rubber caps. Insert a flat-bladed screwdriver into the position
indicated by the arrows and remove the panel. Remove the screws of
each speaker unit and then remove the speaker units.
TE
L 13942296513
Type.3
Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel. Turn the speaker unit to
counterclockwise direction while inserting a flat-bladed screwdriver
into one of the hollows arround speaker unit, and then remove the
speaker unit. After replacing the speaker unit, install it turnning to
clockwise direction unitil "click" sound comes out.
www
.
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
Type.4
2 9
8
How to Remove the PANEL, FR
1. Insert the (-) flat head screwdriver tip into the gap between the
PANEL, FR and the PANEL, SPKR. Tap the head of the (-)
flat head screwdriver with the plastic hammer head, and create
the clearance as shown in Fig-1.
2. Insert the cut chisel in the clearance, and tap the head of the
cut chisel with plastic hammer as shown in Fig-2, to remove
the PANEL, FR.
3. Place the speaker horizontally. Tap head of the cut chisel
with plastic hammer as shown in Fig-3, and remove the
PANEL, FR completely.
Q Q
3 6 7 1 3 1 5
Fig-1
How to Attach the PANEL, FR
Attach the PANEL, FR to the PANEL, SPKR. Tap the four
corners of the PANEL, FR with the plastic hammer to fit the
PANEL, FR into the PANEL, SPKR completely.
co
.
-73-
9 4 2 8
TOOLS
1 Plastic head hammer
2 (-) flat head screwdriver
3 Cut chisel
0 5 8 2 9 9 4 2 8
Fig-2
Fig-3
m
9 9
9 9