Panasonic KX-TVP100E Installation Manual And Instructions For Use page 258

7.1 Utility Commands
Type "ELOG", then press [RETURN].
$ ELOG
DEVICE
1. CPU
2. CLOCK
3. DISK
4. DSP*
5. DSP*
6. CPU
Note:
Device error log indications
Indication
CPU MEM-GET
CLOCK
DISK DATA R/W (xx:yyyy)
DSP* SCAN
DSP* FIFO
CPU APPLICATION (x)
7-6
Maintenance
ERROR
MEM–GET
DATA R/W (xx:yyyy)
SCAN
FIFO
APPLICATION (x)
* = Port number
Types of errors displayed on the screen and their meanings are as
follows:
* = Port number (1 – 4)
TIME
JUL-14 14:00 PM
JUL-14 14:00 PM
JUL-14 14:00 PM
JUL-14 14:00 PM
JUL-14 14:00 PM
JUL-14 14:00 PM
Meaning
CPU card software memory acquisition error.
CPU card is short of memory temporarily because
of too much traffic.
Clock access error. Clock IC is out of order.
Check the hardware.
HDD access error. If there is a sector which
often causes errors, check the disk.
xx : IDE error code
yyyy : read/write error sector number
DSP-SCAN error. DSP is out of order. Check
the hardware.
DSP/FIFO error. During the system is handling
calls, there is wrong with DSP and FIFO memory
temporarily.
Application error. During the system is handling
calls, temporal application error occurs.
x: port number