To Replace The Cord Set - Dimplex BF5000NT Parts & Service Manual

BF5000NT, BF5000, EF2604, SF2603, DF2603
If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE THE CORD SET

1. Remove the firebox trim by grasping both sides of the trim and pulling straight up.
2. Remove the firebox from the mantel.
3. Remove the (4) retaining screws on the top cover and remove the top, placing it
upside down on the top of the unit being careful not to damage any of the wiring.
4. Locate and disconnect the power cord wiring connections noting their original
locations.
5. With needle nose pliers grasp the power cord strain relief grommet from inside the
rear of the heater panel and push while twisting to remove.
6. Pull the power cord out through the hole in the rear of the top heater pan.
7. Install the new power cord through the hole in the rear cover and connect all of the
wiring connections in their original locations.
8. Install the power cord strain relief grommet on the replacement power cord and
insert into the mounting hole in the rear of the top heater pan.
WARNING: Ensure wires do not come in contact with moving parts by securing
wires in wiring tie wraps.
9. Reassemble in the reverse order as above.
16