D20 Front Bezel - IBM pSeries 7311 D10 Service Manual

D20 Front Bezel

Before performing the following procedure, read the "Safety Considerations" on page 41.
Front Bezel Removal
To remove the front bezel, do the following:
1. Open the front rack door. If necessary, place the Model D20 subsystem into the service position as
described in "D20 Service Position" on page 113.
2. Simultaneously press in both bezel-release tabs. See the following illustration for bezel-release tab
locations.
3. Pivoting the bezel from the bottom, swing the top of the bezel out.
4. Pull the bottom of the bezel up, and then away from the subsystem chassis. This action releases the
two tabs located on the bottom of the bezel.
5. Put the bezel in a safe place.
1 Rack Door
2 Bezel
Front Bezel Replacement
To replace the front bezel, do the following:
1. Open the front rack door. If necessary, put the Model D20 subsystem into the service position as
described in "D20 Service Position" on page 113.
2. Insert the two tabs located on the bottom edge of the bezel into their locking slots, located on the
chassis.
3. Pivot the front bezel up toward the top of the chassis.
4. Align the release tabs to the matching slots located on the front of the subsystem chassis.
5. Gently push the tabs into the slots until the bezel seats against the front of the subsystem.
6. If the subsystem is in the service position, put the subsystem back into the operating position as
described in "D20 Operating Position" on page 114.
7. Close the rack door.
116 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
3 Bezel-Release Tab (Located
on each side of bezel)
4 19-Inch Rack