D10 Fan - IBM pSeries 7311 D10 Service Manual

D10 Fan

Before performing the following procedure, read "Safety Considerations" on page 41.
Hot-Swap Fan Assembly Removal
To remove a hot-swap fan, do the following:
1. Locate the cooling fan assembly on the front of the I/O subsystem.
2. Unscrew the thumbscrew that holds the fan into the I/O subsystem.
3. Pull the fan assembly straight out until it is clear of the I/O subsystem.
2 1
1 Fan 2 Thumbscrew
Hot-Swap Fan Assembly Replacement
To replace your subsystem's hot-swap fan, do the following:
1. Position the fan with the connector (located on the fan housing) facing in toward the I/O subsystem.
2. Insert the replacement fan assembly into the I/O subsystem as far as possible.
3. Screw in the thumbscrew to hold the fan in position.
108 Eserver pSeries 7311 Model D10 and Model D20 Service Guide