D10 Covers - IBM pSeries 7311 D10 Service Manual

D10 Covers

Before performing the following procedure, read the "Safety Considerations" on page 41.
Service Access Cover Removal
To remove the service access cover, do the following:
1. Put the I/O subsystem into the service position as described in "D10 Service Position" on page 43.
2. Loosen the two captive thumbscrews located on the rear of the cover.
3. From the rear of the I/O subsystem, lift the cover and slide it backwards until the front disengages. Lift
the cover off the I/O subsystem drawer.
1 Service Access Cover
Service Access Cover Replacement
To replace the service access cover, do the following:
1. Position the cover over the rear of the I/O subsystem.
2. Align the service access cover with the I/O subsystem so that the front portion of the cover engages
with the front part of the I/O subsystem chassis. The flanges on the left and right sides of the cover
should be on the outside of the I/O subsystem chassis.
3. Hold the service access cover down and slide it forward toward the front of the I/O subsystem. The
front edge of the service access cover engages the front portion of the I/O subsystem.
4. Push in to engage and then tighten the thumbscrews located on the rear of the cover.
44 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
2
1
2 Thumbscrews