Fuses - Mercedes-Benz 2008 CLS 550 Operator's Manual

2008 cls-class
Table of Contents

Advertisement

Practical hints

Fuses

The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.
Warning!
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.
i
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to advise
you on this subject.
428
If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
A fuse chart is located in the fuse box in
the passenger compartment. The fuse
chart explains the fuse allocation and fuse
G
amperages.
i
In case of a blown fuse contact Roadside As-
sistance or an authorized Mercedes-Benz Cen-
ter.
The electrical fuses are located in different
fuse boxes:
Fuse box in passenger compartment
( page 429)
Fuse box in trunk ( page 429)
Before replacing fuses:
Apply the parking brake ( page 59).
Make sure the gear selector lever is set
to position P ( page 169).
Turn off all electrical consumers.
Turn off the engine ( page 60).
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver's door.

Advertisement

Table of Contents
loading

This manual is also suitable for:

2008 cls-class2008 cls 63 amgCls-class 2008Cls 63 amg 2008Cls 550 2008

Table of Contents