Mercedes-Benz 2008 CLS 550 Operator's Manual page 179

2008 cls-class
Table of Contents

Advertisement

Controls in detail
Automatic transmission
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the
operating temperature has been reached.
Shift into reverse gear R or park position P only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.
178
Gearshift paddles (example illustration
vehicles with AMG-Sport Package*)
1 Left shift paddle: limiting gear range or
downshift (in program mode M)
2 Right shift paddle: extending gear
range or upshift (in program mode M)
i
You cannot shift with the steering wheel
gearshift paddles when the gear selector lever is
in position P, N or R.
The following instructions describe opera-
tion of the steering wheel gearshift control
when driving in the automatic program
mode C or S.
Limiting gear range
Warning!
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced
vehicle control. Your vehicle's ABS will not
prevent this type of loss of control.
Briefly pull left shift paddle 1.
The transmission will shift to the next
lower gear as permitted by the shift
program. This action simultaneously
limits the gear range of the transmis-
sion ( page 174).
i
To avoid overrevving the engine when down-
shifting, the transmission will not shift to a lower
gear if the engine's max. speed would be
exceeded.
G

Advertisement

Table of Contents
loading

This manual is also suitable for:

2008 cls-class2008 cls 63 amgCls-class 2008Cls 63 amg 2008Cls 550 2008

Table of Contents