Table of Contents
Advertisement
Operation
Engine compartment
Checking engine oil level with the con-
trol system, CLK 500
When checking the oil level
the vehicle must be parked on level
ground
with the engine at operating tempera-
ture, the vehicle must have been
stationary for at least 5 minutes with
the engine turned off
with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the
multifunction display, do the following:
Switch on the ignition ( page 36).
The standard display ( page 148) should
appear in the multifunction display.
Press buttonk or j on the mul-
tifunction steering wheel until the fol-
lowing message is seen in the
multifunction display:
310
One of the following messages will
subsequently appear in the multifunc-
tion display:
Engine oil level
ok
Add 1.0 qt.
to reach max. oil level
(Canada:
1.0 liter
)
Add 1.5 qt.
to reach max. oil level
(Canada:
1.5 liter
)
Add 2.0 qt.
to reach max. oil level
(Canada:
)
2.0 liter
i
If you want to interrupt the checking
procedure, press the k or j
button on the multifunction steering
wheel.
If necessary, add engine oil.
For adding engine oil, see ( page 312).
For more information on engine oil, see the
"Technical data" section ( page 452) and
( page 454).
Other display messages
If the SmartKey is not turned to position 2
in the starter switch, the following
message will appear:
Turn on ignition
to see engine oil level
Switch on the ignition ( page 36).
Advertisement
Table of Contents
