Table of Contents
Advertisement
Daytime running lamp mode
Turn the exterior lamp switch to
position M or U.
When the engine is running, the low beam
headlamps are switched on.
In low ambient light conditions, the
following lamps will switch on additionally:
Tail and parking lamps
License plate lamps
Side marker lamps
For nighttime driving you should turn the
exterior lamp switch to position B to
permit activation of the high beam head-
lamps.
i
With the daytime running lamp mode
activated and the exterior lamp switch
in position M, the high beam head-
lamps cannot be switched on.
The high beam flasher is available at all
times.
Canada only
The daytime running lamp mode is manda-
tory and therefore in a constant mode.
When the engine is running, and you shift
from a driving position to position N or P,
the low beam headlamps will switch off
with a three-minute delay.
When the engine is running, and you
turn the exterior lamp switch to
position C, the parking lamps
switch on additionally.
turn the exterior lamp switch to
position B, the manual headlamp
mode has priority over the daytime
running lamp mode.
The corresponding exterior lamps
switch on ( page 131).
Controls in detail
USA only
By default, the daytime running lamp mode
is deactivated. Activate the daytime run-
ning lamp mode using the control system,
see "Setting daytime running lamp mode
(USA only)" ( page 160).
When the engine is running, and you turn
the exterior lamp switch to position C
or B, the manual headlamp mode has
priority over the daytime running lamp
mode.
The corresponding exterior lamps switch
on ( page 131).
Locator lighting and night security
illumination
The locator lighting and the night security
illumination are described in the "Control
system" section, see "Setting locator light-
ing" ( page 161) and "Setting night secu-
rity illumination" ( page 162).
Lighting
133
Advertisement
Table of Contents
