Mercedes-Benz 2006 CL 500 Operator's Manual page 276

Checking the engine oil level with the
control system
When checking the oil level
the vehicle must be parked on level
ground
with the engine at operating tempera-
ture, the vehicle must have been sta-
tionary for at least 5 minutes with the
engine turned off
with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the multi-
function display, do the following:
Switch on the ignition ( page 34).
The standard display ( page 142) should
appear in the multifunction display.
Press button k or j on the mul-
tifunction steering wheel until the fol-
lowing message is seen in the
multifunction display:
One of the following messages will sub-
sequently appear in the multifunction
display:
ENGINE OIL LEVEL
OK
ADD 1.0 QT. TO
REACH MAX. OIL LEVEL
(Canada: 1.0 LITER )
ADD 1.5 QTS. TO
REACH MAX. OIL LEVEL
(Canada: 1.5 LITERS )
Engine compartment
ADD 2.0 QTS. TO
REACH MAX. OIL LEVEL
(Canada: 2.0 LITERS
i
If you want to interrupt the checking
procedure, press the k or j but-
ton on the multifunction steering
wheel.
If necessary, add engine oil.
For adding engine oil ( page 278).
For more information on engine oil, see the
"Technical data" section ( page 418) and
( page 420).
Operation
)
275