Table of Contents
Advertisement
If the current seat position falls into a
factory-set position range and the
system recognizes the current seat
position to be rearward enough for
easy entry and exit, the driver's seat
will not move to the rear when the
easy-entry/exit feature is activated.
When entering the vehicle, with the
easy-entry/exit feature activated, the
steering wheel or, depending on your
selection, the steering wheel and driver's
seat will return to their last set position or
a factory-set maximum forward position
when you:
close the driver's door with the ignition
switched on.
or
insert the SmartKey into the starter
switch or press the KEYLESS-GO*
start/stop button ( page 35) once
with the driver's door closed.
i
For safety reasons, the driver's seat will
not return to its last set position with
the easy-entry/exit feature activated if
the system recognizes the last set posi-
tion as an extreme forward position.
Instead, the driver's seat will remain at
or move to a factory-set maximum
forward position. To again fully return
the driver's seat to your last set posi-
tion or to memory position, adjust the
seat to the desired position or press
and hold the respective memory
position switch ( page 120).
Controls in detail
Removing and installing front seat
head restraints
For information on head restraint adjust-
ment, see "Seats" ( page 37).
i
Adjust the head restraint in such a way
that it is as close to the head as
possible.
Warning!
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the center of
the head restraint supports the back of the
head at eye level. This will reduce the poten-
tial for injury to the head and neck in the
event of an accident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an
accident.
Seats
G
113
Advertisement
Table of Contents
