Resetting Detector Zones/Message Types - Bosch UEZ Operation Manual

Message Display / Processing
Resetting detector zones / message types
Enter operating code (see section
Operating Authorisation) and se-
lect zone/message type to be
reset: (see page 12).
reset
Calling up
reset
Resetting
single zones
Resetting single
message types
614–30.0212.0270–01 A2
RESET MESS.TYPE: INTRUSION
INTRUS. INT ZONE 0035 – 16
1
Storage room Entrance 1st floor
TOTAL MESS.TYPE
If the zone cannot be reset by the authorised personnel,
contact the Service Department.
RESET MESS.TYPE: INTRUSION
INTRUS. INT ZONE 0035 – 16
1
Storage room Entrance 1st floor
TOTAL MESS.TYPE
If the type of message cannot be reset by the authorised
personnel, contact the Service Department.
SINGLE
SINGLE
The softkey "SINGLE" resets
all triggered detectors of the
detector zone (e.g. 0035) of
the selected message type.
When all reset detectors are in
stand–by mode, the message
is no longer shown in the dis-
play.
The softkey "MESS.TYPE"
resets all triggered detectors of
all detector zones of the selec-
ted message type (e.g. IN-
TRUSION internal).
When all reset detectors are in
stand–by mode, the type of
message is no longer shown in
the display.
15