Cursor Keys; Key Switch; Sealed Switch - Bosch UEZ Operation Manual

Explanation of Display and Operating Elements
Cursor keys / key switch / sealed switch

Cursor keys

Move to the next position by
pressing the appropriate key
up/down
left/right
1

Key switch

Sealed switch

"General Reset"
614–30.0212.0270–01 A2
1 2
7 8
Storage room entrance 1st floor
0
2 The assigning of operating functions to the position of the key switch can be programmed,
e.g. – internal program on/off
– code operation on/off
If the operator cannot reset the system (e.g. after a sabotage alarm), resetting can be per–
formed without entering an operator code by actuating the sealed switch. This should only
be done after prior consultation with the Service Department. ("General Reset" is only pos-
sible if programmed).
3 4 5 6
9 10 11 12
The requested position of
the cursor within the display
can be selected using the
appropriate cursor keys
(e.g. when selecting
detectors, detector zones or
functions).
Additional information is
displayed.
10