Toshiba Tecra 500CS User Manual page 220

000-book.bk : 10-desk.fm5 Page 241 Thursday, May 16, 1996 2:07 PM
5 Gently press the locking latch down.
The computer slides into place and connects to the port
replicator.
6 Attach the power cable to the NoteDock II's DC IN socket.
7 Connect the power cable to a wall socket.
Windows 95 uniquely identifies each NoteDock II. Every time
you connect the computer to a different NoteDock II,
Windows 95 creates a new hardware profile. This feature is
extremely useful if you have a NoteDock II both at home and
at the office, since Windows 95 automatically determines
which port replicator the computer is connected to, and uses
the correct hardware profile.
To disconnect the computer from the NoteDock II, turn the
computer's power off, lift the locking latch, and remove the
computer.
Using PC Cards in the NoteDock II
The NoteDock II provides two additional PC Card slots. These
slots are Zoomed Video Card and CardBus ready, and function in
the same way as those in the computer.
For information about setting up PC Cards, refer to "Setting Up
Your PC Card for Your Computer" on page 198.
To use the PC Card slots in the NoteDock II, you will need to set
up PC Card support the first time you connect to the NoteDock II.
To set up PC Card support, follow these steps:
1 Click Start, then point to Settings.
2 Click Control Panel.
Windows 95 displays the Control Panel.
3 Select the PC Card (PCMCIA) icon.
4 Follow the setup instructions.
Part I: Getting To Know Your Computer
Using Your Computer on Your Desk
The NoteDock II
241