Disassembly/Assembly Of Camera; Bottom Extrusion; Removal; Removing Bottom Extrusion - Polaroid Digital Microscope Camera Repair Manual

Hide thumbs Also See for Digital Microscope Camera:

Table of Contents

DMC Repair Manual

Disassembly/Assembly of Camera

This section of the Repair Manual describes the Digital Microscope Camera's disassembly and

assembly procedures. Before performing any of the procedures described in this section, make

sure that the camera has been turned off and that its power pack has been unplugged.

Note:

Care should be taken throughout all disassembly and reassembly procedures never

to smudge or soil the camera's anti-alias optical filter or CCD imager.

Bottom Extrusion (Figure 2-2)

1. Remove the two (2) screws securing the bottom extrusion to the front panel.

Note: Bottom extrusion has the tripod mount screw hole.

2. Remove the two (2) screws securing the bottom extrusion to the rear panel.

3. Lift off the bottom extrusion from the camera assembly.

Rear Panel

Figure 2-2. Removing bottom extrusion

Tripod Mount

Screw Hole

Front Panel

Parts Replacement

Table of Contents