Installation - Polaroid Digital Microscope Camera Repair Manual

DMC Repair Manual

Installation

1. Slide the white nylon shoulder washer onto the XSYNC cable assembly making sure that its brim
faces the XSYNC cable assembly.
2. Slide the lug cable over the nut.
3. Snap the black inner shoulder washer over the lug cable and nut making sure that its flat
side faces the lug cable.
Note: Press the nut, lug cable, and the black inner shoulder washer together as one
XSYNC lug cable assembly.
4. Assemble the XSYNC cable assembly and the XSYNC lug cable assembly to the rear panel
as follows:
• Place the XSYNC cable assembly and white nylon washer into its recessed support hole
at the front of the the rear panel. Hold in position with thumb.
• Screw the nut of the XSYNC lug cable assembly onto the XSYNC cable assembly.
• Using a spanner nut driver, tighten the nut securing the XSYNC cable assembly and
the XSYNC lug cable assembly to the rear panel.
Note: Position the XSYNC cable assembly and XSYNC lug cable assembly so that the
cable tabs do not touch the rear panel.
5. Install the rear panel and XSYNC assembly.
36
Parts Replacement