Removing The Ice Maker, The Emitter, And The Receiver - KitchenAid 2003 M Technical Education

THE EMITTER, AND THE RECEIVER
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug refrigerator or disconnect power.
2. Open the freezer door.
3. Remove the ice bin from the freezer door
by pressing in on the latch button, and
lifting the bin off the door shelf.
Ice Bin
NOTE: The ice bin disassembly is shown in the
"Tech Tips" in Section 8.
REMOVING THE ICE MAKER,
Latch
Button
4. To remove the ice maker:
a) Close the spring-loaded emitter door
and open the ice maker door.
Emitter Door
b) Push the ice maker door to the left so
that the right pin disengages from the
pivot arm, then lift the pin out of the
pivot, and remove the left pin.
Ice Maker Door
c) Remove the three screws from the left
side of the ice maker bracket, and the
single screw from the right side.
Left Bracket Screws
4-24
Ice Maker Door
Pivot & Pin
Right Bracket Screw