KitchenAid 2003 M Technical Education page 41

i) Unfasten the defrost heater from the
two metal clips on the right side of the
evaporator, and slide the defrost heater
down and off the evaporator.
Heater Clip
(1 of 2)
DEFROST HEATER
REASSEMBLY NOTES:
1. The evaporator fan motor shroud has a
foam block on each side. Note the position
of these blocks in the photo and make sure
that you reinstall them correctly.
Foam Blocks
Evaporator Fan Motor Shroud
2. Be sure to reinstall the foam block on the
right side of the evaporator, as shown in
the photo in step 11h on the previous
page.
12. To remove the evaporator:
a) Remove the defrost heater from the
evaporator (see step 11).
b) Access the sealed system and dis-
charge the refrigerant into an approved
recovery system.
c) Remove and replace the evaporator.
NOTE: Refer to the "Defrost Heater
Reassembly Notes" to the left when
reinstalling the evaporator.
Lift & Pull Out
4-17
Defrost Heater
Evaporator