Table of Contents
Advertisement
Network Auto Boot is controlled by parameters contained in the
NIOT and ENV commands. These parameters allow:
Refer to the ENV and NIOT commands in the Commands Table in
this Appendix for more details. Also refer to the ENV parameters
in Appendix D.
Restarting the System
You can initialize the system to a known state in three different
ways:
Each has characteristics which make it more appropriate than the
others in certain situations.
The debugger has a special feature upon a reset condition. This
feature is activated by depressing the RESET and ABORT switches
at the same time. This feature instructs the debugger to use the
default setup/operation parameters in ROM versus your
setup/operation parameters in NVRAM. This feature can be used
in the event your setup/operation parameters are corrupted or fail
to pass a sanity check.
Selection of specific boot devices
Selection of systems
Selection of files
Programming of the Boot delay
Reset
Abort
Break
Restarting the System
B-7
B
Advertisement
Table of Contents
