Overview Of Start-Up Procedure - Motorola MVME177 Installation And Use Manual

Hardware Preparation and Installation

Overview of Start-up Procedure

2
What you will need to do ...
Set jumpers on your MVME177
module.
Ensure that EPROM devices are
properly installed in the sockets.
Install your MVME177 module
in the chassis.
Set jumpers on the transition
board; connect and install the
transition board, P2 adapter
module, and optional SCSI
device cables.
Connect a console terminal to
the MVME712.
Connect any other optional
devices or equipment you will
be using.
Power up the system.
2-2
The following list identifies the things you will need to do before
you can use this board, and where to find the information you need
to perform each step. Be sure to read this entire chapter and read all
Caution notes before beginning.
Table 2-1. Start-up Overview
Refer to ...
Hardware Preparation
Hardware Preparation
Installation Instructions
The userÕs manual you received
with your MVME712 module, listed
in Related Documentation
You may also wish to obtain the
Single Board Computer SCSI
Software UserÕs Manual, listed in
Related Documentation
Installation Instructions
The userÕs manual you received
with your MVME712 module, listed
in Related Documentation
The userÕs manual you received
with your MVME712 module, listed
in Related Documentation
EIA-232-D Interconnections
Port Numbers
Disk/Tape Controller Data
Installation Instructions
Front Panel Indicators (DS1 - DS4)
Troubleshooting the MVME177;
Solving Start-up Problems
On page ...
2-4
2-4
2-12
1-9
1-9
2-12
1-9
1-9
A-1
B-34
C-1
2-12
3-3
F-1