Table of Contents
Advertisement
Configure and Environment Commands
ENV Parameter and Options
Bug or System environment [B/S]
Field Service Menu Enable [Y/N]
Remote Start Method Switch
D
[G/M/B/N]
Probe System for Supported I/O
Controllers [Y/N]
Negate VMEbus SYSFAIL* Always
[Y/N]
Local SCSI Bus Reset on Debugger
Startup [Y/N]
Local SCSI Bus Negotiations Type
[A/S/N]
Ignore CFGA Block on a Hard Disk
Boot [Y/N]
Auto Boot Enable [Y/N]
Auto Boot at power-up only [Y/N]
Auto Boot Controller LUN
Auto Boot Device LUN
Auto Boot Abort Delay
D-6
Table D-1. ENV Command Parameters
Default
S
Y
B
Y
N
N
A
Y
N
Y
00
00
15
Meaning of Default
System mode
Display Þeld service menu.
Use both the Global Control and Status
Register (GCSR) in the VMEchip2, and
the Multiprocessor Control Register
(MPCR) in shared RAM, methods to
pass and start execution of cross-loaded
program.
Accesses will be made to VMEbus to
determine presence of supported
controllers.
Negate VMEbus SYSFAIL after
successful completion or entrance into
the bug command monitor.
Local SCSI bus is not reset on debugger
startup.
Asynchronous
Enable the ignorance of the
ConÞguration Area (CFGA) Block (hard
disk only).
Auto Boot function is disabled.
Auto Boot is attempted at power up
reset only.
LUN of a disk/tape controller module
currently supported by the Bug. Default
is $0.
LUN of a disk/tape device currently
supported by the Bug. Default is $0.
This is the time in seconds that the Auto
Boot sequence will delay before starting
the boot. The purpose for the delay is to
allow you the option of stopping the
boot by use of the Break key. The time
value is from 0 through 255 seconds.
Advertisement
Table of Contents
