Installing Software; Connecting The Scanner - Microtek ScanMaker 4 User Manual

From the two screens you have seen, the
available IRQ and I/O address for use with the
AVA-2902E interface card.
If the message "aic78xx" is not listed on the
screen, indicating the SCSI driver is not
installed; refer to the Troubleshooting section.

4. Installing software

1. Launch Windows NT 4.0, log in as
Administrator.
2. Insert the Microtek CD-ROM into your CD-
ROM drive. The Microtek Scanner Software
installer should come up automatically, and list
the available software for you. Click on each
software program in the order they appear on
your screen to install all software components.
Note: If the Microtek Scanner Software Installer is
not automatically displayed on the screen, click
Start, select Run and type d:\cdsetup (where d: is
the drive letter of your CD-ROM).
Step 1 Install Microtek ScanWizard
ScanWizard is a Twain driver used for the scanner to
work with various applications. ScanWizard cannot
be used by itself and requires another program in
order to work.
1. Click Microtek ScanWizard, then follow screen
instructions to start installation.
2. During installation, choose "Adaptec SCSI
Interface Card" as your interface type.
3. Follow screen instructions to complete
installation. When installation is complete,
Microtek ScanWizard for Windows NT
appears as a folder on the Programs menu.
Step 2 Install software application
Install each software application by clicking on the
individual program options.
Step 3 Install Microtek DCR
DCR is Microtek' s proprietary color calibration
technology for use with Microtek color scanners.
With DCR installed, your scanner is capable of
capturing extremely accurate color images.
Step 4 Install documentation reader
Click Adobe Acrobat Reader, then follow screen
instructions until installation is completed. Acrobat
Reader is necessary for reading the manuals on your
CD-ROM.

5. Connecting the scanner

Before connecting the scanner to your computer,
make sure the scanner driver (ScanWizard) is
installed. Take the following steps to connect.
1. Shut down your computer.
2. Connect the card and the scanner, using the
SCSI cable that provided in the scanner package.
Make sure your scanner and computer are
turned off when you perform the connection.
SCSI cable
3. Plug the power cord to the power connector at
the back panel of the scanner, and plug the
other end of the power cord to your AC power
source at wall outlet.
4. Turn on your scanner and wait for all the light
on the front panel to stop blinking.
5. Then power up your computer.
9