Testing Your Scanner - Microtek ScanMaker 4 User Manual

7. Testing your scanner

1. Restart Windows 95/98. Before you restart the
computer, make sure your scanner is on and
ready.
2. Click Start, Programs, Microtek ScanWizard
for Windows, , , , , and then select Scanner Test. . . . .
3. When started up successfully, the screen below
appears.
4. Place your document faced down on the scanner
glass. Center the top of the document along the
horizontal ruler on the scanner.
5. Click the Flatbed Flatbed Flatbed or the TMA Flatbed Flatbed
Microtek Scanner Test program screen. A
preview of your image will be displayed in the
Microtek ScanTest window. This indicates the
Scanner Test was successful and the scanner is
now ready to scan.
6. Close and exit Microtek ScanTest program.
For more details on how to operate your scanner
with ScanWizard, refer to the file Scanwiz.pdf in the
folder Manuals on the CD-ROM.
The Scanner Model shows the scanner
connected to your computer along with
the scanner's SCSI ID.
The "aic78xx" message indicates you
are using Adaptec SCSI interface
card.
The Flatbed button is used for previewing
reflective material.
The TMA button is used for previewing
transparent material.
The SCSI Check acts as a SCSI
probe to verify the location of your
scanner and the scanner ID.
The Reconfigure Equipment allows the
system to update its own internal reference
file and is useful when you have changed
your setup or reconfigured your system.
5
Horizontal ruler
TMA TMA button on the TMA TMA