Pedals; Brake Tension Knob; Brake Pad; Seat - Star Trac Spinner NXT 7000 Service Manual

Pedals

Using a bike pedal wrench such as the Park tool
number PW-3, or a 5/8 inch open end wrench tighten
the pedals weekly. Failure to tighten the pedal can
result in pedal wear or breakage.

Brake Tension Knob

1. Remove the acorn nut and locknut from the
bottom of the brake knob assy.
2. Unscrew the brake knob all the way and the
large brass nut, spring and alignment wedge
will fall out.
3.
Pull the brake knob assy up and out of the
bike.

Brake Pad

1. To remove the brake pad for replacement, first
remove the 2 bolts that hold the brake block
on the frame. The spring and brake pad will
come off.
2. Unscrew the brake pad from the spring and
install a new brake pad assy.
3. Attach the spring/brake assy to the brake
block.
4. Tighten the bolts to 1.45 foot pounds US or 20
kgf/cm Metric.
5.
Test the brake for proper operation.

Seat

1. Loosen the seat adaptor using two 14MM open end wrenches.
2. Lift the seat and adaptor off the seat post.
3. Loosen the seat adaptor enough to take the adaptor off the rails if
the new seat does not have an adaptor and transfer the adaptor
to the new seat.
4. Hand tighten the adaptor on the rails
Star Trac Product Support
Page 15 of 21
800-503-1221
4.