Handlebar / Seatpost Sleeve; Pop Pin; Adjustable Foot; Front Transport Wheel - Star Trac Spinner NXT 7000 Service Manual

Handlebar / Seatpost sleeve

1. (NXT Only)Using a small Allen wrench,
unscrew the small screws at the top of the
plastic insert.
2. Unscrew and pull out the pop pin while pulling
up on the handlebar or seatpost.
3. Pull up the insert while pulling out the pop pin.
4.
Reverse the steps to install. And tighten the
screws to

Pop Pin

1. Pull the pop pin out and lift the seatpost or
handlebar post out of the bike.
2.
Using a 20MM open end wrench, unscrew the
nut holding the pop pin and it will unscrew out
of the frame.

Adjustable foot

1. Using a number 3/4" open end wrench, unscrew the foot.
2. Insert the new foot and screw it in by hand until it is all
the way in.
3. Stand the bike upright and level all four feet.
4.
Tighten the lock nut on each foot.

Front transport wheel

1. Using a number 4 allen wrench, loosen the bolt and remove the wheel
assy.
2.
Insert the new bolt and wheel and thread by hand into the other side and
tighten.
Star Trac Product Support
Page 16 of 21
800-503-1221