Paper Jam Messages - Lexmark 7003-050 X340n Service Manual

Paper jam messages

Repeating jams or jam messages can be caused by any of the following:
•
Faulty pick solenoids or worn cams of the solenoids
•
Faulty flags or springs
•
Worn backup rollers at the reference guide
•
Improperly adjusted reference guide
•
Debris in the paper path
•
Paper not of the specified length
Note: For more information,
Paper jam messages
Message
200 Paper Jam
Remove Cartridge
201 Paper Jam
Remove Cartridge
202 Paper Jam
Open Rear Door
241 Paper Jam
Check Tray 1
242 Paper Jam
Check Tray 2
251 Paper Jam
Check Manual Feeder
290 Scanner Jam
Remove Originals
291 Scanner Jam
292 Scanner Jam
see"Paperpath sensor service check" on page
Explanation
The input sensor under print cartridge is covered too long or is covered during
POR or when Go is pressed after clearing a different jam or problem. The exit
sensor could also be covered. Remove the print cartridge and open the rear
door to remove the media. If the message is displayed after the paper is
removed, the MPF sensor or controller card might be faulty.
Paper is jammed between the MFP input and exit sensor. Remove the print
cartridge to clear the paper path. If the message is displayed after the paper is
removed, the input sensor or controller card might be faulty.
The exit sensor is either covered during POR or covered too long. Open the rear
door to access the jam area. If the message is displayed after the paper is
removed, the exit sensor or controller card might be faulty.
Ensure that the rear door to the printer is properly closed.
Paper is jammed between Tray 1 and the input sensor.
Tray 2 pass thru sensor is covered during warm-up.
Try opening Tray 2. If the tray is difficult to remove, then you may have to remove
the tray above or below the tray to remove the jammed pages.
Sensor at the manual feeder indicates paper is stuck in the path. Remove the
paper, and check the flag/sensor.
Paper in the ADF is covering the paper present sensor. See
check" on page 2-19.
Paper in the ADF is covering the paper present and paper path sensors. See
"ADF service check" on page
Paper in the ADF is covering the paper path sensor. See
on page 2-19.
manuals4u.com manuals4u.com
2-28.
"ADF service
2-19.
"ADF service check"
Diagnostic information
7003-XXX
2-9