Operation Using Advanced Key Functions - Mazda 2009 CX-9 Owner's Manual

CX-9_8Z66-EA-08F_Edition3 Page95
Tuesday, March 31 2009 1:51 PM
NOTE
When turning the ignition switch to the
l
LOCK position, the ignition switch has to
be pushed in from the ACC position and
turned. Without being pushed in, the
ignition switch stops at the ACC position
and the vehicle battery may be discharged
if the ignition switch is left in the ACC
position. When leaving the vehicle, make
sure the ignition switch is turned to the
LOCK position.
If the vehicle is left with the ignition switch
l
not in the LOCK position, a beep sound is
heard and the indicator light flashes to
notify the driver.
Refer to Warning Beep (page 3-17).
Form No.8Z66-EA-08F
Advanced Keyless Entry and Start System
Operation Using Advanced
Key Functions
qKeyless Entry System
This system uses the more traditional
keyless entry buttons to remotely lock and
unlock the doors and the liftgate, and
opens the power windows and the
moonroof.
It can also help you signal for attention.
Press the buttons slowly and carefully.
NOTE
The keyless entry system is designed to
l
operate up to about 2.5 m (8 ft) from the
center of the vehicle, but this may vary due
to local conditions.
The system does not operate when the
l
auxiliary key is in the ignition switch.
With the start knob installed in the LOCK
l
position, the system is fully operational. If
the ignition switch is not in the LOCK
position or the start knob is pushed in, the
system does not operate.
All doors and the liftgate cannot be locked
l
by pressing the lock button while any door
or the liftgate is open. The hazard warning
lights will also not flash.
If the transmitter does not operate when
l
pressing a button or the operational range
becomes too small, the battery may be
dead. To install a new battery, refer to
Maintenance (page 3-5).
Black plate (95,1)
Knowing Your Mazda
3-13