Mazda 2009 CX-9 Owner's Manual page 286

CX-9_8Z66-EA-08F_Edition3 Page286
Tuesday, March 31 2009 1:53 PM
Interior Comfort
Audio System
3. ENTER PIN appears for 2 seconds
which indicates that it is in code input
mode.
4. SR1 - - - - appears which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example: If
the registered ID code is 2323 , input
2323 . At this time SR1 2323 is
displayed. Press the scan button after
the code is input.
(Registered ID code input
determination)
6. Determine the code which has been
input by pressing the scan button.
7. If it does not match the registered code,
SR1 Err is displayed and then it
returns to SR1 - - - - .
8. If it matches the registered code,
SR1 LOCK appears for 3 seconds
which indicates that the code input has
been completed.
9. SR1 LOCK 100 appears which
indicates that the parental lock is
activated. At this time, mute is on and
no sound is heard.
(How to clear the message)
Press any of the following FM/AM,
l
SAT, CD, AUX, CAT, ESN/DISP,
Instant replay, POWER buttons.
Turn the ACC off or insert a CD.
l
NOTE
If an ID code is not input for 10 seconds,
l
"Err" is displayed and it returns to the
former display.
Channel preset buttons 1, 2, 3, 4 and the
l
scan button are used for input of the ID
code. Buttons 5 and 6 cannot be used.
6-46
Form No.8Z66-EA-08F
Black plate (286,1)
Lock cancellation
Setting condition: SAT mode
(Releasing a locked channel)
1. Select a channel to be released by
turning the manual tuning dial.
Example: Select the locked channel
(i.e. 100). At this time,
SR1 LOCK 100 is displayed.
(Registered ID code input preparation)
2. Hold the scan button, then press
channel preset button 6, hold both
buttons together for 1.5 seconds.
3. ENTER PIN appears for 2 seconds
which indicates that it is in code input
mode.
4. SR1 - - - - appears, which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example:
When the registered ID code is 2323 ,
input 2323 . At this time SR1 2323
is displayed. Press the scan button after
the code is input.
NOTE
If "Err" is displayed, go to the
"INITIALIZATION OF ID CODE" section to
reset the ID code to [0000].
(Registered ID code input
determination)
6. Determine the input code by pressing
the scan button.
7. If it does not match the registered code,
SR1 Err is displayed and then it
returns to SR1 - - - - .