Operation Using Advanced Key Functions - Mazda 2010 Mazda6 Manual

NOTE
When the push button start is pressed to off
l
from ON, the KEY indicator light (green)
flashes for approximately 30 seconds
indicating that the remaining battery power
of the advanced key is low. Replace with a
new battery before the advanced key
becomes unusable.
Refer to Advanced Key Maintenance (page
3-5)
(Automatic transaxle)
l
If the engine is turned off while the shift
lever is in a position other than P, the
ignition switches to ACC.
Emergency engine stop
Continuously pressing the push button
start while the engine is running and the
vehicle is stopped, or quickly pressing it
any number of times will stop turn the
engine off immediately.
CAUTION
Other than an emergency situation,
do not attempt to stop the engine
while driving the vehicle.
Advanced Keyless Entry and Start System
qKeyless Entry System
This system uses the more traditional
keyless entry buttons to remotely lock and
unlock the doors and opens the trunk lid,
and opens the power windows and the
moonroof.
It can also help you signal for attention.
Press the buttons slowly and carefully.
NOTE
l
l
l
l
l
Operation Using Advanced
Key Functions
The keyless entry system is designed to
operate up to about 2.5 m (8 ft) from the
center of the vehicle, but this may vary due
to local conditions.
The system does not operate when the
auxiliary key is in the key slot.
The keyless entry system is fully operational
when the push button start is switched off.
The system does not operate if the push
button start is switched to any position
other than off.
All doors cannot be locked by pressing the
lock button while any door is open. The
hazard warning lights will also not flash.
If the transmitter does not operate when
pressing a button or the operational range
becomes too small, the battery may be
dead. To install a new battery, refer to
Maintenance (page 3-5).
Knowing Your Mazda
3-15