CX-9_8Z66-EA-08F_Edition3 Page362
Tuesday, March 31 2009 1:53 PM
Interior Comfort
Bluetooth Hands-Free
4. (Without the navigation system)
Prompt: Select one of the following:
Pairing options, confirmation prompts,
language, passcode, or select phone.
(With the navigation system)
Prompt: Select one of the following:
Pairing options, confirmation prompts,
language, passcode, select phone or
select music player.
5. Say: [Beep] Pairing options
6. Prompt: Select one of the following:
Pair, edit, delete, or list.
7. Say: [Beep] Pair
8. Prompt: Please say a 4-digit pairing
code.
9. Say: [Beep] XXXX (Speak an
arbitrary 4-digit pairing code. This can
be any combination of 4 numbers.)
NOTE
Record the code as it will be used to program
your device in Step 16.
10. Prompt: Pairing code XXXX (4-
digit number). Is this correct?
11. Say: [Beep] Yes or No
12. If Yes , go to Step 13.
If No , the procedure returns to Step
8.
13. Prompt: Start pairing procedure on
the device. See the device manual for
instructions.
14. Using the device, perform a search
for the Bluetooth device (Peripheral
device).
NOTE
For the operation of the device, refer to its
instruction manual.
6-122
Form No.8Z66-EA-08F
Black plate (362,1)
15. Select Mazda from the device list
searched by the device.
16. Input the 4-digit pairing code set in
Step 9 to the device.
17. Prompt: Please say the name of the
device after the beep.
18. Say: [Beep] XXXX - - - (Speak a
device tag , an arbitrary name for
the device.)
Example: Stan's device.
NOTE
Speak a programmed "device tag" within 10
seconds.
If more than two devices are to be
programmed, they cannot be programmed with
the same or similar "device tag".
19. Prompt: Adding XXXXXX - - -
(Ex. Stan's device ) (Device tag). Is
this correct?
20. Say: [Beep] Yes
21. Prompt: Pairing complete
After a device is registered, the system
automatically identifies the device. By
activating Bluetooth Hands-Free again, or
by activating Bluetooth Hands-Free first
after turning the ignition switch from the
LOCK to the ACC position, the system
reads out a voice guidance, XXXXXX -
- - (Ex. Stan's device ) (Device tag) is
connected .
NOTE
(With the navigation system)
Device registration can also be done by
operating the panel buttons on the navigation
unit. Refer to the separate manual
"NAVIGATION SYSTEM".