Operating Clips With A Computer - Sony PXW-X200 Operating Instructions Manual

i.LINK (HDV/DV) connector (IEEE1394, 4-
pin)
Input/output of an HDV or DVCAM stream can
be enabled by changing "SDI/HDMI/i.LINK I/O
Select" (page 106) of the VIDEO SET menu.
To set the input, select "i.LINK" in "Input Source
Select" (page 106) of the VIDEO SET menu.
A monitor or VTR that supports i.LINK can be
connected.
For details on i.LINK connection, see "Connecting
via i.LINK (FAT only)" (page 129).
Notes
• When "NW&Proxy/USB" is set to "Network&Prxoy,"
signals are not input/output from the i.LINK
connector.
• When "F.Sys" in "System" is set to "UDF" and
"exFAT" mode, signals are not input/output from the
i.LINK connector.
A/V OUT connector (audio/video
composite multiconnector)
By changing the setting of "SDI/HDMI/i.LINK
I/O Select" (page 106) of the VIDEO SET menu,
you can output 2-channel audio and down-
converted SD analog composite signals for
monitoring.
Use the supplied AV connection cable for
connection.
Note
Signals are not output from the A/V OUT connector
during the following settings
• When "NW&Proxy/USB" is set to "Network&Prxoy"
or "USB A."
• When "Format" in "System" is set to 1920×1080/
59.94P, 50P.
Operating Clips With a
Computer
To use the ExpressCard slot of a
computer
If the computer is equipped with an ExpressCard/
34 or ExpressCard/54 slot, you can directly insert
the SxS memory card containing clips recorded
with this camcorder and access to the files.
Notes
• The SxS Device Driver Software and the UDF Driver
Software must be downloaded and installed on your
computer. For details, see "Software Downloads"
(page 174).
• Operation is not guaranteed with all computers.
• Before editing, set the SxS memory card to the read
only status and make a backup of the data to the
computer.
For support information for the driver, visit the
following URL:
http://www.sony.net/SxS-Support/
With a Windows computer, check that a
Removable Disk appears in My Computer. This
indicates normal status.
With a Macintosh computer, an icon is displayed
on the menu bar.
To connect with a USB cable
When you connect the camcorder to the computer
using the supplied USB cable, the memory card in
the slot is acknowledged as an extended drive by
the computer.
When two memory cards are mounted in this
camcorder, they are acknowledged as two
independent extended drives by the computer.
Note
The camcorder does not work on the bus power from the
computer.

Operating Clips With a Computer

127