Sony PXW-X200 Operating Instructions Manual page 102

CAMERA SET
Menu items
Rec Review
Setting the
playback time for
Rec-Review
TLCS
Setting the Total
Level Control
System (auto
adjustment system
of gain, exposure
and shutter)
Shockless
White
Setting the
shockless white
balance
White Switch
<B>
Setting for the
WHITE BAL
switch
ATW Speed
Setting for Auto
Tracing White
Balance
102 Setup Menu List
Subitems and setting values Contents
3 sec / 10 sec / Clip
Level
+1.0 / +0.5 / ±0 / –0.5 / –1.0
Mode
Backlight / Standard /
Spotlight
Speed
–99 to +99 (+50)
AGC
On / Off
AGC Limit
3 / 6 / 9 / 12 / 18 dB
AGC Point
F2.8 / F4 / F5.6
Auto Shutter
On / Off
A.SHT Limit
1/100
1/150
1/200
1/250
A.SHT Point
F5.6 / F8 / F11 / F16
Off / 1 / 2 / 3
ATW / MEM
1 / 2 / 3 / 4 / 5
Set the time to play the last recorded clip using the Rec-
Review function.
3 sec: Last 3 seconds
10 sec: Last 10 seconds
Clip: Entire duration of the clip
Set the target level (to make brighter or darker) of auto iris
control in TLCS. (This setting also affects the gain control in
AGC mode and shutter-speed control in Auto Shutter mode.)
+1.0: Approx. one stop further open
+0.5: Approx. half a stop further open
±0: Standard
–0.5: Approx. half a stop further closed
–1.0: Approx. one stop further closed
Set the auto iris control mode in TLCS.
Backlight: Backlight mode to reduce darkening of the center
subject against lights
Standard: Standard mode
Spotlight: Spotlight mode to reduce blown-out highlights on
the center subject in the spotlight
Set the tracing speed of TLCS control.
Turn the AGC (Auto Gain Control) function on/off.
Set the maximum gain in AGC.
Set the iris point for switching to auto-iris and AGC (Auto
Gain Control) control when AGC is on.
Turn the Auto Shutter control function on/off.
Set the maximum shutter speed in Auto Shutter control.
Set the exposure position for switching auto iris and auto
shutter control when Auto Shutter is on.
Select the speed of change in white balance when the white
balance mode is switched. Set to "Off" to instantly change the
white balance.
Select a larger number to change the white balance more
slowly through interpolation.
Select the white balance adjustment mode selected at the B
position of the WHITE BAL switch.
Set the tracing speed of ATW. The larger the number you set,
the speed becomes faster.