Sony PXW-X200 Operating Instructions Manual page 105

AUDIO SET
Menu items Subitems and setting values Contents
AGC Spec
–6 dB / –9 dB / –12 dB /
–15 dB / –17 dB
CH1&2 AGC Mode
Mono / Stereo
CH3&4 AGC Mode
Mono / Stereo / Off
1KHz Tone
On / Off
Wind Filter CH-1
On / Off
Wind Filter CH-2
On / Off
Wind Filter CH-3
On / Off
Wind Filter CH-4
On / Off
EXT CH Select
CH-1
CH-1/CH-2
Audio Output Monitor CH
CH-1/CH-2 (CH-3/CH-4)
Setting for audio
CH-1+CH-2 (CH-3+CH-4)
outputs
CH-1 (CH-3)
CH-2 (CH-4)
Output CH
CH-1/CH-2
CH-3/CH-4
Alarm Level
0 to 7 (4)
Beep
On / Off
Select the audio input level AGC.
Select auto tuning for the input level of an analog audio signal
recorded to CH-1/CH-2.
Mono: Perform for each channel.
Stereo: Perform in stereo mode.
Select auto tuning for the input level of an analog audio signal
recorded to CH-3 or CH-4.
Mono: Perform for each channel.
Stereo: Perform in stereo mode.
Off: Do not perform auto tuning. The Limiter Mode setting is
applied.
Turn the 1-kHz reference tone signal on/off.
Turn the wind filter for CH1 on/off.
Turn the wind filter for CH2 on/off.
Turn the wind filter for CH3 on/off.
Turn the wind filter for CH4 on/off.
CH-1: To record the CH1 external input signal to both CH-1
and CH2 (when the CH-2 AUDIO IN switch is set to
EXT). If "CH4 Input Source" is set to "External," you can
also record to CH4.
CH-1/CH-2: To record each external input signal to its
respective channel.
Select the audio channel(s) to be fed to the headphones and
the built-in speaker.
CH-1/CH-2 (CH-3/CH-4): Stereo
CH-1+CH-2 (CH-3+CH-4): Mix
CH-1 (CH-3): CH-1 (CH-3) only
CH-2 (CH-4): CH-2 (CH-4) only
( ): with Output CH set to "CH-3/CH-4"
Select audio output channels from either channels 1 and 2 or
channels 3 and 4.
Set the alarm sound volume.
Select whether or not to sound a beep upon each operation.
Setup Menu List 105