Basic Operation Procedure - Sony PXW-X200 Operating Instructions Manual

Recording

Basic Operation Procedure

4
Open the lens cap
Preparations
1
Mount a fully charged battery pack.
2
Load SxS memory card(s).
If you load two cards, recording is continued
by automatically switching to the second
card when the first card becomes full.
3
Adjust the angle of the LCD monitor for
the best view.
When you wish to use the EVF, fold the LCD
monitor to its park position and adjust the
angle of the EVF.
4
Open the lens cap.
Pull up the lens cap open/close lever to open
the lens cap built in the lens hood.
5
Set the power switch to the ON position.
The recording screen is displayed.
When using the remote commander, activate the
remote control mode (page 21).
28 Basic Operation Procedure
3
LCD monitor
6
angle
adjustment
FULL AUTO
7, 8
REC START/STOP
9
REC REVIEW (on the grip)
1
Battery pack insertion
2
SxS memory card slots
Note
When you hold the camcorder by the grip, support it
from underneath with your left hand.
Recording (Full Auto mode)
6
Press the FULL AUTO button so that
the button indicator lights.
Full Auto mode is turned on, TLCS (Total
Level Control System) (page 102) is
activated, Auto Iris, AGC (Auto Gain
Control), Auto Shutter, and ATW (Auto
Tracing White) are set to ON, then,
consequently the brightness and white
balance will always be adjusted
automatically.
When you wish to adjust them manually, turn
Full Auto mode off, and see;
"Iris" on page 33
"Gain" on page 32
"Electronic Shutter" on page 33
"White Balance" on page 31
5
Power switch:
ON (the " position)