Mounting The Fireray 50/100Rv; Mounting The Prism Reflector - Bosch Fireray 50 Product Information

Product Information Linear Smoke Detector Fireray 50/100RV

7.2. Mounting the Fireray 50/100RV

D To make mounting easier, you can remove the detector cover by gently raising the
upper and lower edges.
D The mounting slots (see Fig. 3.), which are positioned at a 90_angle, enable vertical
or horizontal mounting of the detector.
D Locate the four bore holes at the mounting location using the detector base plate.
Observe the planning notes and mounting tips!
D Check the plug connector and the DIP switch settings (see Section 7.1.).
D Secure the detector using four screws.
D Refit the detector cover.

7.3. Mounting the prism reflector

D Select the mounting location in line with the mounting tips (Section 7.).
D A prism reflector must be used for the Fireray 50RV, and four prism reflectors
arranged in a square for the Fireray 100RV.
D Each reflector is secured using two mounting bores. Arrange the four reflectors for
the Fireray 100RV such that there are no mounting holes in the center (see Fig. 4.).
If a key switch is required, a two- wire cable should be routed from the
detector within reach during installation (see Section 7.4. for connection
details).
Fireray 50RV
Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì
Fig. 4.: Prism reflectors
There must be a free visual line between the detector and
reflector. The IR light beam must not be blocked by moved
objects!
Fireray 100RV
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Ì Ì Ì Ì Ì Ì Ì Ì Ì
Seite 12 von 22
PI - 34.85
601-F.01U.002.705
A1.en / 29.12.2004
ST-FIR/ PRM1/ zab