H201Ti Id And Powerstat. Id; Relays/Analog Submenu (Extended Menu Only); Gas H Relay - GE Hydran 201 i Instruction Manual

Note: In the versions 2.1 and prior of the H201Ti embedded software, in the Call OnAlarm
mode, the telephone number set in the modem's register 0 is dialed automatically at
midnight. This function does not exist in version 2.2.
4.5.6.5

H201Ti ID and PowerStat. ID

The H201Ti ID parameter is used to set the Hydran 201Ti's identification number. An
exclusive identification number must be assigned to each H201Ti in a local network.
The PowerStat. ID parameter is used to set the power station's identification number. The
same power station identification number must be assigned to all H201Ti's in a local
network, but each local network must have a different power station identification number.
The default values of the H201Ti ID and PowerStat. ID parameters are therefore usually
modified. Furthermore, the H201Ti and power station's identification numbers must
correspond to those assigned to the same H201Ti's and power station in the Hydran Host
software.
The identification number of at least one H201Ti in a local network
WARNING
CAUTION
must be set between 1 and 5 (inclusively).
Note: The identification number of each H201Ti must be recorded during the configuration
of the local network.
4.5.7

Relays/Analog Submenu (Extended Menu Only)

The Relays/Analog submenu is used to:
• Read the state of the alarm relays: On or Off.
• Set the operation mode of the three alarm relays.
• Select the triggering conditions of the fail alarm (FaultTrig.).
• Read the state of the analog output and TDM signal (in %).
• Set the operation mode of the analog output and TDM signal.
4.5.7.1

Gas H Relay

• RelayH State: Displays the status of the High alarm relay. The two possible states are
explained in Section 10.2.2 on page 10-4.
Part 17997 Rev. 6, March 2011
Main and Extended Menus
4-23