Store & Send; Auto Telephone; Decode; Code - Kenwood TK-3180 Function Reference

20 DTMF
20.2.9 Store & Send
This function allows a user to store entered DTMF codes
using the Keypad, then transmit them at one time. You
can send a DTMF string that consists of a maximum of 30
digits.
You can enable/disable the Store & Send function using
KPG-89D.
!
Configuration using KPG-89D
•
Configuring the Store & Send function (Refer to
FPRG 6.10.1.Encode tab - Store & Send.)

20.2.10 Auto Telephone

You can enable/disable the Auto Telephone function. You
can use this function when the [Side 2]/ [!] is pressed in
Autodial Mode.
You can enable/disable the Auto Telephone function
using KPG-89D.
!
Configuration using KPG-89D
• Configuring the Auto Telephone function (Refer to
FPRG 6.10.1 Encode tab - Auto Telephone.)

20.3 Decode

You can configure the following functions that are linked
to the DTMF Decoder using KPG-89D.
•

Code

•

Transpond/ Alert Tone

• Stun
• Auto Reset Timer
• Clear to Transpond
• Selective Call Alert LED
20.3.1 Code
Code is a standby code for an individual call.
The transceiver emits the Alert Tone and the Call Alert
LED lights orange when the Code matches. A user can
communicate only with the QT/DQT according to the
selected operation in Decode Response.
!
Configuration using KPG-89D
• Configuring the Code (Refer to FPRG 6.10.2
Decode tab - Code.)
84
20.3.2 Transpond/ Alert Tone
The transceiver performs the
function when the code matches. The selected
operations in
when the code matches.
You can configure
89D. Below is a list of configuration items for the Alert
Tone and Transpond.
Table 20-4 Transpond/ Alert Tone Operation
Function
Alert Tone
Transpond
Note:
" The Alert Tone sounds after transponding when using the
Transpond function and Alert Tone function at the same time.
" The Alert Tone is held since the channel is busy while
configuring the Clear to Transpond operation.
" The Alert tone stops when any key is pressed while it is
intermittently emitted if "Infinite" is selected in the Special Alert
Tone window > Cycle edit box "Infinite". The received tone is
preferred when the Alert Tone is intermittently emitted.
" The match status of DTMF resets in the following condition.
Table 20-5 Condition to Reset the DTMF Match State
Operation
Press a key.
On-hook
Timer
expires.
Code
reception
Function Reference
Transpond/ Alert Tone
Transpond and Alert Tone is performed
Transpond/ Alert Tone using KPG-
Operation
The transceiver emits the configured Alert
Tone.
The transceiver performs the Transpond
function. The transceiver overwrites the
Transpond Tone and transmits it.
Condition
One of the following keys is pressed.
•
PF Monitor key
•
PF Monitor Momentary key
•
PF Squelch Off key
•
PF Squelch Off Momentary key
•
PF Zone Up key
•
PF Zone Down key
•
PF Zone Up/Down key
•
PF CH/GID Up key
•
PF CH/GID Down key
•
PF CH/GID Up/Down key
•
PF Scan key
•
PF Home Channel key
•
PF Direct CH/GID 1 - PF Direct CH/GID 5
key
The microphone status becomes On-hook.
Auto Reset Timer expires.
Receiving Code + # code
Version: 1.11